- Joined
- Dec 6, 2014
- Messages
- 21,221
Disassembly can be done by leaving the pan with the crankcase, but I don't recommend it.
To remove the pan, the rear bar stud needs removed...
To remove the pan, the rear bar stud needs removed...
I don't know where he whacks it at.I have broken fins on flywheels that way on 1123 saws. Pullers are easier.
So not really the best AV then, but better engine vibes?
I don't know where he whacks it at.
The 029, 029 Super and MS290 here came with 3/8 std sprockets as well. I have never seen a stock 1127 saw with .325 in the PNW. None of mine had anything other than the 3/8 spur drive and 3/8 std B&C (I have had over a dozen of them). I swap them out with the 036 rim drive brake/clutch drums. The smaller pre-360 rim drive hub works fine and can be swapped in if one of the OP's 036 is upgraded with the later larger 360 clutch drum kit. The later 360 clutch drum is recommended on the 036 to keep them from grenading. The 036 rim drive is a good pro feature that you can swap into these saws to replace the spur sprockets.
Pretty much the same here, but I just hold the flywheel in my hand.I remove the flywheels by loosening the nut, screwing it back on most of the way but leaving 1/8" if space between it and the flywheel. Then I put a 1/2" deep well socket on the nut (it's actually 13mm but the 1/2 fits tighter), pick up the saw about an inch off the bench by holding a flywheel fin firmly with a duck bill pliers and give the socket a firm rap with a 12oz brass hammer. One rap does it every time. Screw the nut off,
Here is a good video on repairing this series of saw.
Also many others if you search on youtube.
I do need to upgrade bearing and drive on one of my saws. Thanks for the reminder!
Not sure what you have near you hondabond, yamahabond can usually be had at said dealers. Permatex and loctite have their own versions of an anaerobic gasket maker (518).Also 1194 and 1184 are popular but usually have to be purchased online. Stihl uses dirko. Permatex has a hylomar product and a couple non hardening flexible gasket makers. Almost all can be found on ebay, amazon, or online $10 to 15 shipped.[QUOTE=" Any recommendations for flange sealant that would be available locally? Fastenal killed me on shipping last time
[QUOTE=" Any recommendations for flange sealant that would be available locally? Fastenal killed me on shipping last time
A hammer of course! But not a sledge hammer...Hitting the flywheel?
Where? With what?
I don't think you're supposed to hit the fins. Poulan uses this method in their service manuals on some of their saws, I tried it and now use it on many different saws. You really don't have to hit it hard, a few light taps is enough on many of them..I have broken fins on flywheels that way on 1123 saws. Pullers are easier.
Enter your email address to join: