They work slick Randy! All the saws I have used Rivet nuts on are out right now or I would snap a few shots. They sure turn out nice though!
I have had zero issues doing muffle mods this way.
I have had zero issues doing muffle mods this way.
Pretty thin flange on the LP style, but for this application should be fine. Most of the meat of the fastener is hidden back inside the can. For something like a mirror on a sheet metal truck door the heavier, thicker flange keeps it from punching through the other way. (inward). Smallest one I have used are 1/4" They sure are the cat's meow.I got a kit from McMasterCarr.
I'd like to have some of the low profile ones....
But the ms362 is awesome!!!261cm's rock
Hello Mike.
This thread is a "must read".
There will be a test.
At least two...How many ms261s you figure you've done now, Randy?
Paging Chadihman warm up the DynoClearly Randy, you have the 261 figured out. Are you seeing the same power increase out of the 362cm once ported?
How many ms261s you figure you've done now, Randy?
Clearly Randy, you have the 261 figured out. Are you seeing the same power increase out of the 362cm once ported?
In the trunk?Bump.
Enter your email address to join: