Now that my MS660 issues might of been solved I now have issues with my MS361. It is very, very hard to start and I will tell what I have to do to actually get it started.
Remember once started it runs just fine, like it always did, cuts fine, no issues once actually running.
Steps:
Set to choke
push compression button in
pull on chord until I smell gas, it never "tries to fire" like it supposed to during this
next move to start position and pull the heck out of the chord, and then after 5-15 pulls of giving it your all it will actually start. This step works better if you leave the compression button out, I do not push it back in after it pops out.
Once started I can goose the throttle to kick the lever into the 'on' position and then it runs just fine.
Once started I just can't shut it off. lol, besides I am too tired to actually cut after doing all that pulling to start it.
What would be the first things to check/change.
Thanks for any help
Sent from my SM-N920V using Tapatalk
Remember once started it runs just fine, like it always did, cuts fine, no issues once actually running.
Steps:
Set to choke
push compression button in
pull on chord until I smell gas, it never "tries to fire" like it supposed to during this
next move to start position and pull the heck out of the chord, and then after 5-15 pulls of giving it your all it will actually start. This step works better if you leave the compression button out, I do not push it back in after it pops out.
Once started I can goose the throttle to kick the lever into the 'on' position and then it runs just fine.
Once started I just can't shut it off. lol, besides I am too tired to actually cut after doing all that pulling to start it.
What would be the first things to check/change.
Thanks for any help
Sent from my SM-N920V using Tapatalk