I've been buying Oregon for quite some time. Maybe 15 years.
This past couple years, in my opinion, has gotten garbage lately.
Chain doesn't keep an edge after like 3 trees., and sharpens ridiculously fast on the dremel.
I pieced together some stuff from the 60s I had laying around just to get by this last week, and all I do is grind grind grind to get an edge and center hole to match next pin size. Super hard steel. Out I went and made days without sharpening.
Anyone else have this soft issue with Oregon? Alternatives?
I'm scared to buy a roll......afraid I'll get 25ft of copper or brass. Well. Not literally, but may as well be.
Sent from my s-off'ed m7 with CM11
This past couple years, in my opinion, has gotten garbage lately.
Chain doesn't keep an edge after like 3 trees., and sharpens ridiculously fast on the dremel.
I pieced together some stuff from the 60s I had laying around just to get by this last week, and all I do is grind grind grind to get an edge and center hole to match next pin size. Super hard steel. Out I went and made days without sharpening.
Anyone else have this soft issue with Oregon? Alternatives?
I'm scared to buy a roll......afraid I'll get 25ft of copper or brass. Well. Not literally, but may as well be.
Sent from my s-off'ed m7 with CM11