Replacement Oregon bar tip rivets

[cbfarmall]

I am venturing into something I've never done before--replacing a bar tip. Now, the tip is an old Oregon roller nose, 2 7/8" diameter, that I found NOS. Picked up some standard Oregon rivets thinking they would work but clearly are too large.

What are the proper rivets for this tip? Is there something else that can be used? I ordered the rivets from Bailey's, but maybe I should talk to them over the phone.

Thanks, Chris B.

 

[RaisedByWolves]

Can you measire them?




I have hunnerts of rivets, and Id be more than glad to send you some Chris.



Its the least I could for you!

 

[ray benson]

Measured a spare rivet. See pic.
A= .185"
B= .260"
Length= .260"

 

[cbfarmall]

Ray's measurements seem about spot on. Let me know what you find RBW. Thanks for checking Ray.

Chris B.

 

[RaisedByWolves]

The ones I have are in a bag marked "Kileda power equipment" and measure...


A=.160

B=.205

Length=.230


I believe these are for Sandvik/Winsor bars, but they are smaller.



Let me know if these will help.

 

[cbfarmall]

RBW,

They are a little small, but may work. Maybe you can hook me up with 6 or so to try out. I'll drop you a PM.

Chris B.