AOD
Addicted to ArboristSite
Okay, here goes. My little Solo trim saw has had the single bar mount stud work it's way loose. I go to tighten it, I put the nut on it tight and turn it in. Only problem is I can't get it to tighten down, I think the threads inside the casing are partially stripped.
Could I smear epoxy all over the stud threads and twist it in? I was thinking of cleaning the inside of the threads with carb cleaner and Q-tips, and doing the same to the stud threads. I really don't want to have to replace the whole casing.
Oops, wrong forum.......my bad.
Could I smear epoxy all over the stud threads and twist it in? I was thinking of cleaning the inside of the threads with carb cleaner and Q-tips, and doing the same to the stud threads. I really don't want to have to replace the whole casing.
Oops, wrong forum.......my bad.