Fellas -
Have an 084 and I'm curious about market price. It's #116339XXX.
Has an NOS full wrap handle.
Quench is set at .020. Base gasket delete. Believe compression is right at 200 psi, but have to check my notes. Definitely need to use the decomp on this one.
Piston and jug are OEM and in very good condition. Has new Caber rings.
Tillotson HT7 carb is rebuilt.
New OEM fuel line. New OEM intake.
Almost new 36" Carlton sprocket tip bar. .404 chain in good condition.
Muffler is OEM and ported; excellent condition.
Unlimited coil setup; matching flywheel, of course.
Fresh top end, just fully cleaned and reassembled.
Does not have HD air filter.
Plastic is all in good shape; just scratches here and there. Unless noted above (i.e., Caber rings), all parts are OEM/NOS Stihl.
Built it with the intent to sell it to my neighbor, who wants to get into milling. Don't want to sell it to him at cost, but I don't want to screw him over, either. Just would like to figure out what the going rate is on a saw in this condition, and sell it to him for something less than that.
Thanks,
Scott
Have an 084 and I'm curious about market price. It's #116339XXX.
Has an NOS full wrap handle.
Quench is set at .020. Base gasket delete. Believe compression is right at 200 psi, but have to check my notes. Definitely need to use the decomp on this one.
Piston and jug are OEM and in very good condition. Has new Caber rings.
Tillotson HT7 carb is rebuilt.
New OEM fuel line. New OEM intake.
Almost new 36" Carlton sprocket tip bar. .404 chain in good condition.
Muffler is OEM and ported; excellent condition.
Unlimited coil setup; matching flywheel, of course.
Fresh top end, just fully cleaned and reassembled.
Does not have HD air filter.
Plastic is all in good shape; just scratches here and there. Unless noted above (i.e., Caber rings), all parts are OEM/NOS Stihl.
Built it with the intent to sell it to my neighbor, who wants to get into milling. Don't want to sell it to him at cost, but I don't want to screw him over, either. Just would like to figure out what the going rate is on a saw in this condition, and sell it to him for something less than that.
Thanks,
Scott