mikerudder
Chainsaw Enthusiast
Just throwing this out there for the saw builders out there.
I have 2 660/066 builders and an 064 builder.
4 660 cylinders and 1 piston
1 064 cylinder
Stash of carbs, coils, clutches
3 - 3/4 wraps
Recoil, top covers, AF covers etc.
All of them would most likely need to be torn down and rebuilt, needing a few parts as well.
I would like to get a built saw out of the deal to run in an alaskan mill.
If there is any interest out there, send me a PM and we can go from there.
Would also be willing to trade for a milling saw - Stihl of course!
I have 2 660/066 builders and an 064 builder.
4 660 cylinders and 1 piston
1 064 cylinder
Stash of carbs, coils, clutches
3 - 3/4 wraps
Recoil, top covers, AF covers etc.
All of them would most likely need to be torn down and rebuilt, needing a few parts as well.
I would like to get a built saw out of the deal to run in an alaskan mill.
If there is any interest out there, send me a PM and we can go from there.
Would also be willing to trade for a milling saw - Stihl of course!