stihl MS441 throttle cable

[Mack Gregg]

new to the site i searched for this but didnt see a answer so here is my question.

On a MS441 that i just rebuilt was reassembling and going to put the carb on the throttle cable doesnt seem right. In front of the ball on the cable there is a small what i call a brass farrow that im assuming is suppose to travel on the cabel and mine does not. I also figure this is what locks the cable in place on the linkage unless i am doing something incorrect but i cant find any pic diagrahms of how to route the cable to see if im doing it incorrect thanks for your time and any help or insight is appreciated.

 

[HarleyT]

The ipl doesn't help much.

 

[HarleyT]

P.M. me your e-mail. I'll send you the manual through g-mail.

 

[L34]

Yes the ferrel is what operates the throttle not the ball on the end.
Chris.

 

[HarleyT]

Yes the ferrel is what operates the throttle not the ball on the end.
Chris.

 

[Mack Gregg]

Yes the ferrel is what operates the throttle not the ball on the end.
Chris.

i figured that was suppose to move not sure why all the sudden it is not i have that soaking in penetrating oil and also ordered a new cable for a backup if that doesnt break free. it doesnt appear to be frayed at that brass farrrow

 

[Wood Doctor]

See Section 12 of the Service manual. It might be a hair better than the IPL.

 

[L34]

What do mean move?
It should be crimped to the cable.

 

[L34]

View attachment 885617

Or is it fuerrel.
Or is it just an Aussie term?

 

[BangBang77]

Ferrule.

 

[Cruelsun]

Ferrule.

X2

Sent from my Pixel 3 XL using Tapatalk

 

[Cruelsun]

Ferrule.

^^ X2 ^^


Sent from my Pixel 3 XL using Tapatalk