newmanab
ArboristSite Lurker
I have a 24hp Yanmar diesel out of a john deere lawn tractor. All it needs is fuel injectors.
So this is where i'm at:
I don't have a splitter at the present time. Was going to buy one, but thought i would have to spend about $2,000 to get one with decent cycle time and power.
So could it be done with this engine? Or would i be wasting my time.
I have no clue about size of cyl., pump, I-beam, how much of a hydro fluid should the system hold. i would like it to have auto cycle. What else should i be planning for?
I can weld, but don't have any smarts on hydro's
Sorry to be so ignorant on the subject, but looking for some advise.
Right now i have a CB-6048, but long term goal is to buy a gasser in a few years and it sounds like a splitter will be a must.
Thanks In advanced.
So this is where i'm at:
I don't have a splitter at the present time. Was going to buy one, but thought i would have to spend about $2,000 to get one with decent cycle time and power.
So could it be done with this engine? Or would i be wasting my time.
I have no clue about size of cyl., pump, I-beam, how much of a hydro fluid should the system hold. i would like it to have auto cycle. What else should i be planning for?
I can weld, but don't have any smarts on hydro's
Sorry to be so ignorant on the subject, but looking for some advise.
Right now i have a CB-6048, but long term goal is to buy a gasser in a few years and it sounds like a splitter will be a must.
Thanks In advanced.