Tractorsaw1
ArboristSite Guru
I'm getting ready to put new seals on a 490 Jonsered & a 330 poulan - if anyone has these worm gear pullers to let go hit me up, i tried to order one at the dealer & NLA
You can become a Supporting Member which comes with a decal or just click here to donate.
You don't want the one I'm looking for. You need 530031115. It will work for the 490 and 330.I'm getting ready to put new seals on a 490 Jonsered & a 330 poulan - if anyone has these worm gear pullers to let go hit me up, i tried to order one at the dealer & NLA
How is the 325 gear different from the 490? I would have assumed they were the same.You don't want the one I'm looking for. You need 530031115. It will work for the 490 and 330.
Depending on the year of your 490 they did come with the same oiler gear as the 55 Husky. Later ones came with the course gear like on my 5500. The 50's and 55's all use the same earlier gear. At least that what all the ipls I have show.How is the 325 gear different from the 490? I would have assumed they were the same.
A while back I made a puller for the 490/5000 etc and remember it was a bit more of a pain than most, being a very course left hand worm/thread.
Was hoping it was going to be an easy one like the 50/55's where a 1/2" pipe fitting can be adapted...
So which one do you need?Depending on the year of your 490 they did come with the same oiler gear as the 55 Husky. Later ones came with the course gear like on my 5500. The 50's and 55's all use the same earlier gear. At least that what all the ipls I have show.
Looking over the IPL's you will find the later Partner 500/5000 came with it too. So it just depends on the year of the saw. It is probably why some IPL's dont show the gear separately and only the whole kit with oiler and the gear. That way as long as you use the gear in the kit you would be good to go.
Umm, the one listed in the first post...So which one do you need?
Thanks Bill, to be honest I never looked close enough to see if the coarse thread was left hand. I will double check that. I appreciate the offer and may take you up on it.Ok, I didn't go back and re-read the first post which would have made that more obvious, lol.
So it's the left hand thread one...
When I made mine, the threads on the first one came out a little big/loose so I popped out another tighter one while I was set up for it.
I see no reason why it wouldn't work fine anyway, the threads are pretty deep so still plenty of engagement, pm me an address and I'll get it out to you.
Yep - i guess ill order a nut Thanks for that info - i have not tore down the 490 & this is the keeper
$3 at mcmaster carr
Well crap - I don't know what I have as I have not tore it down
Enter your email address to join: