This actually started out in the Milling Forum and then I took the saw apart
![Cry :cry: :cry:](/styles/default/xenforo/bigcry.gif)
Previous post:
Log wizard on Stihl MS180
Can the log wizard be used on the Stihl MS 180? What can I do to keep the saw from burning out? My wife is cleaning some cedar logs and the saw gets hot and quits running. We usually run 40:1 (Stihl requirement is 50:1) with premium gas but switched to 25:1 will that help or hurt the motor?
Unfortunately that is the only saw my wife can start. We are using the logs whole for a pole barn and don't have the option to wait until Spring when freshly cut life cedar is easy to peel. We are using dead standing and fallen trees.
It is a MS 180 CB, not electric, runs on gas. Displacement 31.8cc,
it is an occasional use saw. The wife has been cutting smaller cedars and oaks and debranching etc. for 2 years without problems.
It runs the wizard but suddenly has a really hard time starting. Once it runs on full throttle it does fine but when you let it go down to idle it dies and then doesn't want to start again. Acts as if it is flooded.
I'll go out later and clean her up put fresh gas in with less oil etc. and see what happens.
Well, Ive cleaned everything up and didn't see anything suspicious. However, I heard a hissing sound where the fuel hose goes into the tank. I turned the saw upside down and it seems to leak gas somewhere in that area. So I guess I will be taking everything apart to see what's going on and also check the crank seal.
The hissing sound comes from the little valve on top of the gas tank and when the saw is sideways it leaks.
Now I still haven't figured out why the saw doesn't want to start or run in idle
![Confused :confused: :confused:](data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7)
I'll have to order a new piston. Is there anything else I need to replace?
In the meantime is there another easy to start saw that I could get for my wife?