Big Block
WFO or I don't go
?
Speaking of Stihls. I tried Deaks (Campbell River)that's cause treeslinger is likely the best saw builder in CA and Bob gets **** done local. i'm not sure Jasha is taking work right now. haven't seen him around for a while now. i hear he makes a killer stihl.
Speaking of Stihls. I tried Deaks (Campbell River)
461 on the hill and then later another Faller had one of his 660's. I couldn't believe how smooth he makes them. That was the only reason I didn't switch to the stihl (461) These were by far a lot smoother than my 372 spring mounts. I am referring to 'air cutting' specifically, comming on and off the trigger. They don't have a shimmer in them anywhere. I imagine alot has to do with how open his exhaust is. When I trigger off, it drops to nothing almost instantly. I keep looking down and hitting to trigger as it fools me in thinking it just stalled. No wind up time at all. They are instant. Completely on edge. I don't think there is a lot of longevity but I don't care about trivial things like that.
Now of course they will go to av mounting and auto tune.
Another guy just got a new Simonized 461 and usually he runs 390's and he said his is rough incomparison to his 390
Different things matter to different operators that'sfor sure. If I do end up buying a couple of 461 before they change them then there is only one guy a would go to on thesmoothest grounds alone.
So you're saying round chain makes you stupid?!!660;s rattle your brains out with round.
I was specifically talking about throttling up and down with no load or short duration cuts as in limbing but good point. In order to have the all around effect of his saw I would likely have to use quare chisel. Yes they both had Sq grounddid you notice if they were using square ground? 660;s are pretty smooth with square but they rattle your brains out with round. i'm debating switch right now. either 461 stihl or 7910 dolmar.
haha only on rubber mounts. I have been running spring mounts with round for 20 yrs now and there is nothing wrong with me... wrong with me... wrong with me.....So you're saying round chain makes you stupid?!!
I'm throwing all mine out right now.
The word "Tag" is just Internet forum speak for; "This is a cool thread with interesting info that I"ll wan't to get back to later" So I"ll just "Tag" it for now.
Sent from my SM-G900R4 using Tapatalk
Matt is handing it to me after his cut.
Muffleris there but it has a big hole in it
Any video?
Sent from my SM-G900R4 using Tapatalk
I think the mm on Hedgerow's saw allows you to check the piston without taking the muffler off.
Does that thing even have a muffler on it?!
Enter your email address to join: