so either go around the nipple hole or go with a gasket I will see if i can get a gasket.
so either go around the nipple hole or go with a gasket I will see if i can get a gasket.
LMAO, did YOU read the whole thing? You asked if we could tell you which piston to use.
Yeah, I saw that. Look, you're getting fed up and pissed off at this saw, they can be frustrating. If it was me, I'd take a night off. Go back to it tomorrow and tear it down.
We'll get it going eventually.
Yes I am,
but the beer can sounds good but i ask again if the jug fits tight to the can gasket and that fits tight to the base How will the impluse nipple get air? If it need's to send air to the carburator how can it get air if everything is flush?
Leave a notch in the gasket. The hole in the base matches up with a hole in the cylinder, right? Just make sure your gasket doesn't cover the hole. Simple.
Jeff, I feel for you. This saw is causing too much grief. I read all about the gasket issue your having and can't quite picture it in my head. My Husky 50, ran with both a gasket and not gasket. Maybe a picture or two would help. Back to the not wanting to run right, try a coil and Flywheel off a known good runner. If the coil's are different it might need the matching flywheel to make spark. Good Luck, oh yeah the upside to using the beer cans is you gotta empty one first Good luck man and DON'T give up.
Well good night for now gonna go dream on it one more time.
Nice offer! I'd most likely have any of the parts needed, I can supply them at no cost.ALLL..Righty Then........you're having quite a time Jeff.....if this goes beyond your willingness to fight it any further put it in a box and send it to the coast......I'll find the problem, fix it and send it back to you for the cost of parts and shipping...not advertising just trying to help...that is a nice looking saw and should perform well. These small motors are very finicky and not everyone is cut out to deal with them...just sayin...
Night, good luck with that thing. If you want to take some pictures and have trouble posting them, let me know, I'll help you through it.
Enter your email address to join: