Porting The MS201T
- Thread starter Mastermind
- Start date
Help Support Arborist Forum:
old-cat
Fir Man
.006" ain't easy to do!
MCW
Somebody's talking crap here & it ain't the tree!
It's interesting that a number of guys in the US have stated that the "2nd Gen" 201T's aren't a patch on a 200T. Guys in Australia that have run them are saying that they are a huge improvement over the original 201T that was an absolute disaster and are pretty well now matching a 200T.
I'm wondering whether the US versions are still tuned too lean (or detuned?) to satisfy the EPA?
I'm wondering whether the US versions are still tuned too lean (or detuned?) to satisfy the EPA?
Mastermind
Work Saw Specialist
Tune does mean everything on these saws Matt........
MCW
Somebody's talking crap here & it ain't the tree!
I know. The original 201T and MS261 I imported from the states were absolute lean out disasters. The Australian models were never released anywhere near that lean.
bryanr2
Addicted to ArboristSite
will there be a video of this bad boy?
Mastermind
Work Saw Specialist
I doubt it Steven. I've been testing in little pecker poles these last few weeks.
Hey Moobs, what does a MMMS201T cost?
Saw, Bananas, B/C set up, and shipping to Walton Mnt?..
Mastermind
Work Saw Specialist
I'd have to price the saw.....
Port work is less than "normal price" though. I can't do quite as much, so I don't charge quite as much.
Port work is less than "normal price" though. I can't do quite as much, so I don't charge quite as much.
Okie Dokie Pokie.
fastLeo151
Addicted to ArboristSite
What "stage" would you consider this randy
Mastermind
Work Saw Specialist
3.14
Pie stage.
Pie stage.
fastLeo151
Addicted to ArboristSite
Had to ask ole buddy
bryanr2
Addicted to ArboristSite
Sierradmax
ArboristSite Operative
Any clearance issues with the transfer inlet inside the jug after base gasket was deleted?
I like that 
Mastermind
Work Saw Specialist
I didn't check.......I just trimmed it the thickness of the base gasket to be certain.
how do you think the charging of the transfer ports would be affected if the extension to the crankcase was cut off and chamfered.....suppose it would raise the crankcase volume and reduce mixing and turbulence.....?
sap can
sap can
Mastermind
Work Saw Specialist
I really believe it would add too much case volume. That would kill velocity....
Is the coil limitation higher than the 1st gen.? I have an early model which hits the limiter at 13,200-13,300. It is a nuisance to tune. I've heard that the latest offering has a different coil & speculation that it hits the limiter around 14,000?
