mga
wandering
i bought my husky 350 last year. it's a great saw and it's been nice to me until yesterday. i was using it and heard a metallic vibration. i noticed one of the muffler screws came loose.
ok...so i tighten it and the other one and restart the saw and continue cutting. then, same noise....this time i loose the screw in the snow. sheesh. so, to finish, i tighten the other and keep going. then, after about 20 minutes....the damn muffler falls off!!! $#!$#$@#$@!#$@@#!
i didn't see any lock washers on them, so what holds them tight? now i gotta go get two screws and a gasket. but, why would they keep coming loose? should i put loc-tite on them? or should i just use lock washers?
ok...so i tighten it and the other one and restart the saw and continue cutting. then, same noise....this time i loose the screw in the snow. sheesh. so, to finish, i tighten the other and keep going. then, after about 20 minutes....the damn muffler falls off!!! $#!$#$@#$@!#$@@#!
i didn't see any lock washers on them, so what holds them tight? now i gotta go get two screws and a gasket. but, why would they keep coming loose? should i put loc-tite on them? or should i just use lock washers?