Geo019t
ArboristSite Lurker
I have a Milwaukee 2727-20 M18 Fuel saw which uses Oregon .043" ga. 3/8"P chains -- requiring an 11/64" file to sharpen. I LOVE the Pferd/Stihl 2-in-1 jigs for my Stihl chains on my019t, 26, and MS 390 saw chains, but as much as I looked -- I cannot seem to find one for 11/64" chain.
My question, not knowing the "physics" of the 2-in-one sharpeners, is: If I simply replace the 5/32" files in a jig I have with 11/64" files -- will this work? As 5/32" IS "10/64"" -- perhaps that extra 64th of an inch might work? BUT, on the other hand, might it puts the jig out of whack??? I do not know if the plastic dimensions of each different-sized jigs are not the same, dependent on file size -- or -- do they use the same jig for all (unlikely?) just swapping the files in them.
Your thoughts will be appreciated!
geo
My question, not knowing the "physics" of the 2-in-one sharpeners, is: If I simply replace the 5/32" files in a jig I have with 11/64" files -- will this work? As 5/32" IS "10/64"" -- perhaps that extra 64th of an inch might work? BUT, on the other hand, might it puts the jig out of whack??? I do not know if the plastic dimensions of each different-sized jigs are not the same, dependent on file size -- or -- do they use the same jig for all (unlikely?) just swapping the files in them.
Your thoughts will be appreciated!
geo