Nice job on the dinosaurs Robin...LOL
Looking real good, they will be nearly new when you are done and should out last you,..your`e not going to go cutting wood with them are ya?
Thanks Jerry The 49Sp will continue on as it was, being used when needed (but this will be number 7 for those), It will not be expected to preform the service it used to. But still a very usable, useful, used tool. The 70 E, on the other hand will be nearly new with all the NOS parts I am using including a NOS recoil cover and clutch cover. You're probably right, other than a few tanks now and then will most likely be more of a shelf queen. The 70E is quite heavy and not a super performer by today's standards...good power and torque..and a very usable saw....but not a screamer.
And now the next set of pics......
074...closeup of NOS points set and pkg of NOS cam wipers.
075...Points plate and dust cover.
076...Points installed in the plate and wire soldered to the condenser Note the piece of paper between the contacts...shipped that way to keep the contacts apart but it also measures 0.016" which is the points setting and thus makes a suitable "feeler gage" Do you suppose that's what they were thinking???? Works for me..
077...Same pic just a bit better shot.....
078... inside of dust cover with NOS cam wiper installed.