You gotta be kidding me!
Just run everything at 50:1.
So, you're telling me that 50:1 won't be too lean for the Poulan?
Your google fu is weak. Nobody with half a brain runs 40:1 unless you are running drain oil as your mix oil. More oil does nothing for any stock saw made in the last 40 years except make it run hotter and leaner. Another oil thread by an expert who read something on the internet.
Must be something in the way I type. Every time I write something on here, some hotshot has something to prove. There must be a lot of people out there with only half a brain. I hope we can all someday pair up, make whole brains and praise your knowledgeable input. So, more oil makes the saw run leaner? The more oil I put in, the less there is? If you could just reach behind you and give a quick tug, I think your head is stuck!
I didn't realize that I needed to keep a pot with me every time I log in here. Apparently, this is a forum for pissing contests and I am going to need something to hold it in.
Perhaps I will just look for some other site. Probably all the same as this one though.
~M