Can you post a pic of stamped I.D numbers on bar pls? To be sure-to-be-sure the bar is the problem here. .067 is not uncommon for an .063 bar. If it were 063 the chain wouldn't turn. Its either packaged wrong, stamped wrong, hung on the wrong rack or dealer mixed up bars with cardboard sleeves. 'If' the chincy bar has I.D codes stamped we'll know where the mistake was made. I don't believed this to be a tolerance mistake, most likely its a human error along the supply chain. Usually 063 is used on Stihl mounts but I've got 063 husky mount AM bars from Tsumura etc. What mount is it?
Fixed it for yaWow... could have been that the chinese just don't give a ****. Again..
Wasn’t planning to buy them. Life is too short to buy cheap crap, or off-brand crap, in order to save a dollar.
Wasn’t planning to buy them. Life is too short to buy cheap crap, or off-brand crap, in order to save a dollar.
The bars are clearly marked .058.
I have a well used bar of high quality and it only has .003 clearance. If someone in a store tried to sell me a bar with .004 clearance I would not accept it. A bar with .009 clearance is at the point where I consider throwing them away. Expecting to even get enough use out of a bar with this clearance to run out the life of one chain is wishful thinking.
I contacted Huztl and this was their response:
"In response, we discussed with our technicist, and confirm the bar couldn't affect using, pls have a try, thanks."
Really? Maybe using for display, I don't use bars with AK-47 manufacturing tolerances.
I was actually thinking of buying one of the Joncutter saws because of the good reviews, but now I won't because of the experience with these.
Pics of I.D on bar? You have high quality bars that have 003" clearance which your happy with but would reject 004" . Well my advice would be to pay for good quality & stop buying your bars from Hutzl which is no surprise come from PRC. But you still haven't put up ID pics, your telling people NOT to buy a certain product, is it unreasonable to provide proof to back it up. I still think you have an 063 bar that is well within tolerance @067"....prove me WRONG.The bars are clearly marked .058.
I have a well used bar of high quality and it only has .003 clearance. If someone in a store tried to sell me a bar with .004 clearance I would not accept it. A bar with .009 clearance is at the point where I consider throwing them away. Expecting to even get enough use out of a bar with this clearance to run out the life of one chain is wishful thinking.
I contacted Huztl and this was their response:
"In response, we discussed with our technicist, and confirm the bar couldn't affect using, pls have a try, thanks."
Really? Maybe using for display, I don't use bars with AK-47 manufacturing tolerances.
I was actually thinking of buying one of the Joncutter saws because of the good reviews, but now I won't because of the experience with these.
Enter your email address to join: