J.Walker
Addicted to ArboristSite
- Joined
- Aug 20, 2006
- Messages
- 3,570
- Reaction score
- 1,772
- Location
- The Bristol Mountains, Western N.Y.
A 2002 Jonsered. Used off CL.
Looks fast!
.
Looks fast!
.
Last edited:
A 2002 Jonsered. Used off CL.
Looks fast!
.
A 2002 Jonsered. Used off CL.
Looks fast!
.
Yes the boot is 503611301 and the clamp is 503591601. I just bought these in May, so don't let the Husky dealer tell you they are NLA. Should cost about $15 for both.
I tried those part numbers on line and could not find them. I do have a dealer local here and will try that next. Thanks.
If you can't find them.... PM site sponsor spike60...he's a Jred dealer...if they're available he can/will get them for you...good guy to deal with Too!!
Nice! that would come in handy since those old covers cannot be had at the friendly saw shop.
Nice! that would come in handy since those old covers cannot be had at the friendly saw shop.
Well, darn, I found it on Bailey's site, and in the Q&A section they say it won't work on a Jred 670. That's not what I've read
The cover on the 266 extends back over the the top handle, which unlike the 670, is bent inward (the handle) so the cover clears. The 670 cover ends along the front edge of the handle and could be used as is on a 266. If you cut the 266 cover extension off it would work fine but wouldn't look quite the same as the 670. Or alternatively you'd have to also put a 266 top handle on the 670 (and then the 266 brake bar would line up at the same angle too, without bending it).
My 670 needs some brake hardware and I figure by the time I buy that I'd be close to the price of replacing my functional but cracked one with a $50 scratched up but complete feebay one. Other saws keep sucking down the parts funds though...
Bill
Enter your email address to join: