Maybe as tight as you can get them left handed without grunting. Lol. Tighten them in 3 stages in an x pattern
Is it twisting within the length of the bit or stripping out inside the plastic handle? Do they feel like they're tight enough?I did this. After a certain point all it’s doing is twisting the long Torx...
Is it twisting within the length of the bit
Do they feel like they're tight enough?
I guess I can't comment because I haven't experienced that. The bit I use doesn't flex a noticeable amount within itselfYes.
Probably, but I don’t like not having a solid feel of it.
I guess I can't comment because I haven't experienced that. The bit I use doesn't flex a noticeable amount within itself
One of them screws onto the top of the jug. The other looks like a grommet used to protect the wires coming through the case, can’t be sure though.Putting it back together.
Two little rubber pieces I need to figure out where they go.
View attachment 716888 View attachment 716889 View attachment 716891 View attachment 716893 View attachment 716896
YepLeft is the wire grommet, right is the brake handle bushing (on the left-side of the brake handle)
So the grommet goes on the wiring harness to the ignition module?
There are 2 that are nearly identical. Both are for the same wires. One goes in the aluminum case where the wires exit the recoil compartment and the other goes in the back bottom left of the carb boxI confirmed this in the manual.
That one has potential to not want to fit. I've pressed them in with the vise before
right is the brake handle bushing (on the left-side of the brake handle)
Enter your email address to join: