Hey all,
Bought a new ms881 few weeks ago, probably ran 10 tanks or so though it.
once the saw is warmed up and been cutting for a while it has a tendency to run on a bit after a cut, kinda like chopping the throttle causes it to fast idle almost. Haven’t had a chance to take it back to the dealer yet to get his thoughts.
Any ideas??
Bought a new ms881 few weeks ago, probably ran 10 tanks or so though it.
once the saw is warmed up and been cutting for a while it has a tendency to run on a bit after a cut, kinda like chopping the throttle causes it to fast idle almost. Haven’t had a chance to take it back to the dealer yet to get his thoughts.
Any ideas??