JeffreyZirkle
ArboristSite Member
I am running a 404 bulk roll chain, right side of the chain always files out perfect but the left side all ways appears that the file is not making contact with the tooth cutting edge and is just removing material from the gullet. I do not notice it until I am 2/3 of the way through the chains life. Then the saw will start sawing at an angle rather than a strait line. I do measure my teeth to make sure they are all the same length.
Also I am noticing around the 2/3 Mark I get a broken master link and must install a new one.
Sent from my SM-N920R4 using Tapatalk
Also I am noticing around the 2/3 Mark I get a broken master link and must install a new one.
Sent from my SM-N920R4 using Tapatalk