CC specialty 182
http://www.ccspecialtytool.com/182mc-right-angle-handpiece
http://www.ccspecialtytool.com/182mc-right-angle-handpiece
It's worth it thoughDamn that's pricey
Im not sure which head I'm going to buy yet. I'm going to get in touch with member Scarr on here see what he has. I live in Cresson.Redfin, great work there bud.
If you get a right hand tool, I'm interested to see what type.
This CAD is bad.
Where in PA are you?
I see a small lathe in my future as well.
i drive by you a few times a month when i take my son to visit his momIm not sure which head I'm going to buy yet. I'm going to get in touch with member Scare on here see what he has. I live in Cresson.
Where are you from?i drive by you a few times a month when i take my son to visit his mom
indiana paWhere are you from?
Your grinding looks great!
looks like fine work, and your low speed mixture screw sounds a touch lean but only a touch.
You are very Welcome.Thank you.
I went back into the carb that day. The lever was a tad to high. Its all good now.
Enter your email address to join: