Stihl Livin
I DON'T EVEN BURN WOOD
I have an older 026 sitting on my bench that has a fuel leak when running and seems to need to be tuned after it warms up. I can get the saw to start and there is fuel slowly leaking and building on top of the tank. I pulled the fuel line and that seems to be good but I haven't tested it yet as I am just ordering a mighty vac kit. I pulled the carb and when I reinstalled it the barb fitting that goes into the impulse hose seems to slide in easier than the fuel line slides on, is this normal or worn? Also when I got it running I had to adjust the carb to get it to run and idle properly. After I got it warmed up and restarted it I had to readjust the carb again. I'm thinking I should just start off with new fuel line and rebuild the carb but is there something I'm missing? Any help is greatly appreciated.