buttercup
Addicted to ArboristSite
View attachment 759146
Personalized my smurfs this way. Not as impressive as yours but people chuckle.
That's abusive.
View attachment 759146
Personalized my smurfs this way. Not as impressive as yours but people chuckle.
Why?That's abusive.
Here’s what I did, what most people do. Three slices with a dremel cutoff wheel and open them up with a screw driver and pair of duckbill pliers. I run 16 inch .325, perfect combo. I had a 18" .325 on it and like the 16 much better.
View attachment 759163
View attachment 759164
Nice , thank you . I’ll deff wait till it’s broken in first .Yes you will definitely notice a difference. I waited till the saw was fully broken in. Make sure you remove the muffler if you do this, you don’t want any metal shavings going into the cylinder. Blow out the muffler real good with compressed air before reinstalling. My two go to saws are just like you, 461 and 261. You can’t beat that combo.
Enter your email address to join: