I don't have either one of those saws.
Stopby .....I'll be moving so I wont be using them....
I don't have either one of those saws.
Stopby .....I'll be moving so I wont be using them....
I think this is the list so far.
If I missed you or have you in the wrong category just holler at me and I will fix it.
Planning on attending
Grandpatractor
Heavy Fuel
wi50
redlinefever
wdchuck
nikocker
Curlycherry1
Thorcw
triptester
manyhobies
wendell
heimannm
Steve NW WI
wetgunpowder
GrizzlyAdams86
kevin j
JeepNJesse
McManus
Philbert
Johnzski
woodyman
davec
VINIFIREWOOD
Maybe Attending
jtimm
Your 051 against my 075, bet yours wins.
We'll be moving beginning of March till mid April...........Cant wait till its all done ..........
Might be looking into a GTG down here in late summer .........Its going too be another busy year.....
We'll be moving beginning of March till mid April...........Cant wait till its all done ..........
Might be looking into a GTG down here in late summer .........Its going too be another busy year......
.
I think wdchucks wild thing could beat his 075.
Holy Crap Ultra, what are you using to move? Saddlebags on the bike? Trunk on a Pontiac Fiero? Your pants pockets?
Maybe we could send Heavy Fuel over with the big truck to speed up the process :help:
Almost didn't post,found this on page 4 halfway down.Just wanted to say that it sounds like there will be alot of 7900's at grampatractor's GTG and I can't wait to check them all out.There will be one 7900 I will check out tomorrow and that is thorcw's.We are going to have a little mini GTG,test out the saws and he will be helping me take down some big red oaks that I will try to get a vid of.
The 5100 ran great with 16" bar and 3/8x.050 30RC chain on it.A little jumpie on a couple limbs but overall very good.I set it to 14,200-14,300 WOT RPM's and took out the spark screen.I let Thor use it for awhile and he liked it alot.It didn't come close to the speed my ported 346 has when it comes to the small stuff.It did seem to have alot of power and torque in the bigger wood.We need results of the Great MN 50cc Challenge
we just put togather a saturday night special Stihl 066 from some substandard parts and a few hours with the dremel, lathe and mill. Funky port timeing but it'll walk all over my 066 mag and 660. Wth a little luck it'll hang togather long enough to make it to the GTG. I'm hopeing to get a few hours and make a billet cylinder head to get the comp. up a bit. and of course a pipe, a really loud pipe.
Enter your email address to join: