So can you flash tune the carb to make it think its feeding a bigger saw? In the automotive world Im reflashing modules all week long. GM make some great crap it tell ya, Is there software RE-programable or is it burnt once and then done? Can you get that tool if your not a dealer???
No, there is no custom tuning. No maps. No open ended software. "x" saw has "y" carb, click, program, then ya still gotta run it to let the autotune adjust itself.
And you don't want to tell it to run 562 settings persay on a 555 or 550, as the timing as fuel requirements are completely different. Let the autotune do it's own thing.
There is no need to alter any settings. It's pointless. It's a learning computer. It will tell you you're wrong, it knows what to do, and it will do it. Inputting incorrect information could further lead to damaging the saw as it may not be able to calibrate correctly due to incorrect parameters, or take too long to correct from input that is too far off from what you need.
***Another thing is this - why would you want to manually set a carburetor that is set up for automatic adjustments?? It makes no sense. Buy a saw without AutoTune if you want that..... And with the reports of these computer carbs saws running smoother, better, more powerful than their non-Autotune counterparts, why would you want to even compete with that? One less thing to have to do, adjust a carb. AWESOME!!!!
And sorry, to answer your second to last question there, yes you can reprogram it. You can take the AutoTune unit off one saw and install it on another saw (i.e. from 562 to 555) and reprogram it for the different saw. When you replace the carburetor on these saws, you are replacing just that, the AutoTune unit gets reused unless there is a fault.