Swap meet...

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
I no it's not a chainsaw but I picked up a Ryobi 410R rototiller. Any one have a motor for one of these? Pretty good shape but the piston and cylinder is toast. I have parts to trade.
 
I have a similar rear handle version that I use for carving and I have replaced that pump 3 times in 4 years of carving! Most of the parts saws I come across from that family if saws the pump gears are usually still good so I don't think it was very common.

Sent from my XT1031 using Tapatalk

He is going to get a goober of white lithium grease around the gears when he goes back together.
IMG_0482 (Copy).JPG
 
Tom i have looked high and low for that coil. I have the flywheel if you need it and the muffler and gas tank

i

I know how that is. Like I told you before I have promised someone parts that i knew I had, but could not find them. I appreciate that you looked for it, but I only need the coil. Please just remember me if you run across it. Thanks for the effort. Tom
 
Looking for Husky 372 XTorq hi-top air filter cover and air filter mount for the screw-down filter.

Bolt holes are different on the Xtorq. I think the bolt holes on the filter mount are nearly horizontal on the XTorq- already bought the the wrong one off an XP.
 
before i go the ebay route anybone have any of the following:

036 recoil
026 carb, 2 x air filter, cover
260 handle

not urgent but looking for an ms660 with a bad engine

have 021 engine assembly w/coil perfect shape, 021 handle, ht131 engine, an unknown stihl weedwacker engine, or cash also have a craftsman 3.7/18" with case, extra chain, and tools i can trade, needs the handle bar buffer and carb kit
 
Mantis coil. I have one that was scored. No clue if coil was good or bad, came in apart. I will see if still on the shelf. Been there a couple years now. So red wire coil is the one needed?

Guess I need to look for that poulan muffler cover for a guy too . :oops:
 
Mantis coil. I have one that was scored. No clue if coil was good or bad, came in apart. I will see if still on the shelf. Been there a couple years now. So red wire coil is the one needed?

Guess I need to look for that poulan muffler cover for a guy too . :oops:

Ran out during commercial break during BB game. Mantis coil I have is grey with black wire. Oh well.

Still forgot to look for poulan muffler cover. o_O
 
Stihl 015 3/8 clutch drum.

I know someone had one of these for me and I found the oiler gear on eBay. Just need that drum now...
 
Hey guys I'm needing the little screw that holds on the fuel tank guard for a 044. I do not have another around to compare or I would just get one at the local hardware. I would hate to run the wrong screw in and ruin the plastic threads of the handle. PM me if you can help me out.
 
Anybody want to trade a left bucking spur for the right one?
I need the one from the clutch cover if anybody has one.
Husky 288.
IMG_20140406_134521_517.jpg
 
Long shot mabey, I have Redmax G300ts that I need a coil for, any help would greatly appreciated.
 

Latest posts

Back
Top