Sure is quiet in here....do I need to start a fight?

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Good Samaritan you.
Had an errand one bout crash into me over in Cali couple years back, rather big un close to 3 feet across, 4 big whirley motor rig with 4 blades on each motor, span of about 8" each set. Was adjacent to a park where some retailers were showing off the goods, seen it coming and sidestepped a couple steps, went whizzing by and smacked into a eucalyptus, plastic bits went flying. Operator showed up all outa breath, seen his rig and began whining bout the cost. Good thing it didn`t hit anyone, cost be much greater.
Yep though it was undamaged...….without the control was useless.....so my minute to shine...LOL!!!
 
Little MS201T showed up recently.. had a recent carb swap but still ran poorly and hard starting. I played around fixing a multitude of small issues. Checked compression and while low I thought it was enough at 138. Finally today I popped the muffler off. Well.. the carburetor and all the fighting was trying to tune through a scored P&C. 4 for 4 being junk when I investigated. I bet I fix this and the 200T for him and the MS440 and BR600 are junked.

Yes getting a digital camera to focus down through the access hole is a trick.. I'll get better pics when its apart further.
4d15fe6998c95c986d12b8418267e85d.jpg
a31121fb6c400fa44342e66652e03e5a.jpg
8aba4d58fbe116ec894fafe8d08a88a4.jpg
141eb27e7c38bc4914d1878ddc2156c3.jpg
 

Latest posts

Back
Top