288

[booger1286]

Now you just need to machine the husky cylinders to even things up.

 

[pops21]

Now you just need to machine the husky cylinders to even things up.

They are already.

 

[SawTroll]

I like the KS cylinders, the ones I have seen have been nicer than Mahle IMO.

Husky used a lot of them back then, on different Husky and Jonsered models.

 

[mdavlee]

Now you just need to machine the husky cylinders to even things up.

The 288 has the cylinder I showed you on it. The 395 is the only one without machine work done to it.

 

[mdavlee]

Since I put all the other different saws in here I might as well put the 576 video in this thread also.

<iframe width="420" height="315" src="//www.youtube.com/embed/VgYzPvjhUCA" frameborder="0" allowfullscreen></iframe>

 

[cutforfun]

After the video's the title of this thread should be "046" they all look good but that 046 looks great.

 

[mdavlee]

Yeah the 460 turned out great. The 576 almost sounds like a stock saw compared to the rest.

 

[tramp bushler]

Yup. It will be lots of fun to get the 460 into some real wood. . This one is my 5 th 046/460 and is the first one I've had juiced. As I will be running 36" bars with semi skip chisel ground chisel chain. It has the snort to make me a living. .
I have run them with 36" bars in the past. But mostly 30+32" bars. . My back doesn't like bending over to limb with the short bars any more so all my bushlin saws run 36" any more. I filed down the base abutment on the bar studs on this saw so I can run Husky mount bars on it.

 

[tramp bushler]

The Max Flo filter is an improvement over the factory filter. It is close to the Pro Tek filter which is no longer made. Plus the big cover keeps things pretty well protected from stuff, sow, rain ect. Getting in the Carb box.

Definatly need hearing protection with this saw now.

 

[mdavlee]

Yeah it is real loud now. I like the max flow setup. That's the first saw I've had around that used it.

 

[tramp bushler]

It works best if its cleaned withK+N filter cleaner or Tilex Mildew and Stain remover. And lots of warm water to rinse and then fully air dry. I have mostly used 2 stroke oil as a filter oil. But k+n filter oil would prolly bebetter . When it gets cold. I run the OEM filter and covers. And cover the bottom half of the starter cover.