Sold 394xp crank/case -new bearings and gasket $200 - shipped

[Mattyo]

Fresh case install.... new oem gasket and nachi 6203's. used cases and crank, will be good platform for rebuild.... not perfect but its quite nice.

I don't have seals right now, but if the buyer can wait I have hyway seals coming. Will install at no extra charge. If ya can't wait take it as is and install whatever seals ya like.

No other parts come with the case, not willing to part with anything at this point.

paypal FF preferred. $200 shipped to lower 48

the hard part is done for ya!

-Mattyo

 

[Mattyo]

 

[half_full]

just curious, do you use sealer on all your case gaskets?

 

[Mattyo]

I have been using 1184 on these cases lately
...I'm paranoid hehe

 

[Mattyo]

Let's see who I can tempt. ..

Seals are in. I'll include a flywheel...one of the fins was damaged...so I evened it out. Should still work fine. Not easy to find 394 flywheels. Oiler is installed and dip tube. And loctited.

Flywheel needs to be shored up a bit. Then torqued. It's on gently right now.

Still 200$ shipped.

 

[ELECT6845]

How are those Hyway seals holding up? No offense, but I don't trust them that's why I'm asking

 

[Mattyo]

They look good to me. I don't have tons of time on my saws...so I can't say for sure. I don't use the farmer tech ones ..don't trust those myself hehe.

 

[Mattyo]

Let add one more carrot to get this sold... I have an RWJ -4 xtorq carb that should fit with one of these. used carb, may need a kit. I'll include it for $200 shipped.

 

[Mattyo]

 

[Mattyo]

Bump