Update, finally got it going. New fuel line and filter, intake gasket, carb kit and still wouldn't run. The kit didn't come with welch plug. So after it wouldn't run, went back in and pulled old welch plug. There was very little gunk but I blew out the passage and cleaned. Put back together and would run but still not quite right, fuel starved. Still no idle and running only 1/2 throttle or more. As last resort I went in and bent metering fork a little higher than original setting, which made it above even with body. Now runs good, idles and revs good. High speed screw adjusts normally but low speed doesn't. But I will leave well enough alone as it idles and accelerates properly.