Even 130 would be way low. Something isn't right.
Do the decompression valves ever go badEven 130 would be way low. Something isn't right.
I just pushed it in to verify. To me the Rings look slightly recessed which would certainly be an issueThey can. Is yours snapped out? P&C looks normal from what I can see. The rings don't stick out more than a couple thousandths, which you can't see. Otherwise they'd snag on the port and break.
Yes I just pushed on them with a small jeweler's screwdriver and they moved slightly not a lotCan you see the ring move at all if you push on it with something?
Yes sirZoom in and give us a few pics of some of the "teeth" on your chain.
No. I had a tack laying around here somewhere for a model airplane I wonder if those would work LOLHas anyone suggested that this saw could be a tuned a bit over rich?
I’ve had saws bog when pushed if they were too rich.
A touch leaner and away you go.
I don't tune by ear anymore for thise very reason. (Using a tach now)
That chain is toast.Its dull now. I did get a little bit into the dirt making my last cut on some big logs so what I'll do is that will sharpen it and show you what it looks like after I sharpen it so you can compare
Someone once told me you can keep sharpening it until a tooth breaks off I agree there's not much left and it was sharpened at the wrong angle to start with by the original owner he went to town with it with a stone grinder I usually just give it a good three Strokes with a file either way it shouldn't make the saw bogThat chain is toast.
Enter your email address to join: