Swap meet...

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Looking for a place to get some older J'Red parts:

910 crank seals (difficult?)
a 24"-28" bar (Jonsered or Homelite large studs (10mm?)
bar guide plate(s)

625-630-670 clutch covers (I know with a brake is tough)
bar guide plates
handle(s)

601 & 621 crank seals (set of each, but I think they are the same, anyway)

Any of the above, will help.

Thanks in advance.

ugh...good luck with the 625-630-670 clutch cover...i've been lookin for a while... if you find more than one, let me know!! :D

as for the other stuff, if you aren't in a huge hurry, i will be going through a box of older NOS j-red husky stuff in 2 weeks or so (in the process of changing the cam in the wife's TDI Jetta, work search, family gatherings, etc...so busy for a bit)



Looking for a 066 carb., piston and a rim drum.

Thanks Guys!!!

attachment.php


:poke:
 
Last edited:
Looking for a good 385/390 crank. Have $$ and a few parts laying around.
 
need a few things...

have (lots o) parts or $$ to trade...

Dolmar 112 front AV mounts
066 brake handle
Poulan 306 (etc) oil tank side 'cover' (has the bar studs....:confused:)
Mac 10-10/700 clutch & clutch/brake cover
288xp brake cover

bunch o pistons.... (hopefully...:D before I buy new...)

Husky
41
42
350
268xp
288xp (could use bearings/seals/gasket too....)
394xp

Jonsered
670 piston



Thanks guys! any help appreciated...

:cheers:
 
Last edited:
need a few things...

have (lots o) parts or $$ to trade...

Dolmar 112 front AV mounts
066 brake handle
Poulan 306 (etc) oil tank side 'cover' (has the bar studs....:confused:)
Mac 10-10/700 clutch & clutch/brake cover
288xp brake cover

bunch o pistons.... (hopefully...:D before I buy new...)

Husky
41
42
350
268xp
288xp (could use bearings/seals/gasket too....)
394xp

Jonsered
670 piston



Thanks guys! any help appreciated...

:cheers:


I have a 41 piston in fair shape. Not scored, but it has a small nick in the top edge. I wouldn't hesitate to run it.
 
I have a 036 pro with a regular air filter cover on it. I need a non-pro 034 or 036 air filter. I could also use a new style large rim clutch drum and bearing. This saw has been a labor of love, sweat, blood, and tears. It went from a smashed piece of crap to this. I'm close to being done but not quite yet. :cry:

attachment.php


Here's what I started with. I've had some help from a few folks or I would never have gotten this far. It has a meteor piston kit, new crank seals, and fuel line and filter. I've ported it and hope for a strong runner.

attachment.php
 
I'm needy as hell lately. lol

I need a coil for a Stihl S-10 and a filter cover. Also needing a air filter housing for a Poulan H 200.

Looking for a piston for a MS 210 as well.

Lastly and most important. I need a non-pro 034 or 036 air filter.

I've got lots for stuff to trade.
 

Latest posts

Back
Top