Swap meet...

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Don't know what size it is. I got a cyl and a piston, but no pin.........

Can you get a measurement where the wrist pin goes into the piston and then one of the rod where the little bearing goes? If you can we might be able to help you get something that will work.
 
UP FOR TRADE:
I'm unfortunate enough to have an OEM 064 jug on my bench that I can't use. Its got its warts now (just slotted the bolt holes), but nothing major, see here for reason why... http://www.arboristsite.com/chainsaw/202148.htm#post3702172
Will sell cheap if cash is the only transaction.

WANTED: 038 Mag cylinder; 038 Mag rings (just one actually), 25" Stihl bar/chain

Let me go look? Think I have a 038mag cyl. Back in a few!
 
Anybody have a manual oiler button/rod for a cinder block Mac? aka 610, eager beaver 3.7, timber bear, etc.

I think I have that. I will check and let you know tomorrow. Tom

P S. I found one. It will be in the mail tomorrow. Tom
 
Last edited:
I'm looking for a 026 chainbrake handle. I also need a piston if someone has a spare.

Cash to make the trade equitable for both parties.

PM coming on chain brake handle. I also have one of Brad's OEM 260 p/c's left.
 
Preston,
the dreaded online auction house is your friend for old Stihl parts. Just have to be patient.

Al.
 
im still on the hunt to buy either a new or nice used ms 361 oil pump thanks.

if it's the same as a 036/034 I probably have one for ya!


Looking for:
036/360 cylinder and air filter cover (and AF to match)
360 carb
031 rear black handle
026/260 plastics and mufflers
ms290-390 air filter cover
ms290-390 air diverter (black "L" shaped piece above the air filter)
always taking in ms290-390-029's (preferably cheap and dead)
 
Last edited:

Latest posts

Back
Top