crabby cooter
ArboristSite Operative
Burning the mid nite oil eh ? Is this test using the gutted rubber intake boot or stock ?
stock boot
Burning the mid nite oil eh ? Is this test using the gutted rubber intake boot or stock ?
Great to see you are keeping your ears clean with the cotton buds on standby.View attachment 689053 Off da 261cm ... geese louise ...it’s only a spark -plug right ?
Dip a q-tip in a bottle-cap full of your favorite oil and do some housecleaning ... last thing ya want is dirt/sawdust in the bottom end ... if you do get a bit of debris ya can always flush her out ... My honest thoughts on this are as follows - easiest way to not get **** on your boots is to not Step in it to begin with!Great to see you are keeping your ears clean with the cotton buds on standby.
it always amazes me to see someone post vids of them working on a grubbed up saw ! i clean one to the paint before i even attempt to work on one !Dip a q-tip in a bottle-cap full of your favorite oil and do some housecleaning ... last thing ya want is dirt/sawdust in the bottom end ... if you do get a bit of debris ya can always flush her out ... My honest thoughts on this are as follows - easiest way to not get **** on your boots is to not Step in it to begin with!
What did you write on your cylinder next to your .018 squish number? Fabio? I can’t believe it’s not butter......sprayView attachment 689053 Off da 261cm ... geese louise ...it’s only a spark -plug right ?
.018 squish ? Why that’s total rubbish for a worker ......?What did you write on your cylinder next to your .018 squish number? Fabio? I can’t believe it’s not butter......spray
Why wood anyone run that tight squish when the goal is chain speed ? Worksaw with .018 squish ? Last not too long me thinks.018 squish ? Why that’s total rubbish for a worker ......?
Have you ever run one with .018" squish to test it's longevity?Why wood anyone run that tight squish when the goal is chain speed ? Worksaw with .018 squish ? Last not too long me thinks
Why wood anyone run that tight squish when the goal is chain speed ? Worksaw with .018 squish ? Last not too long me thinks
Mmm ... rpmwhat's it going to hurt?
Mmm ... rpm
Too much compression is rpm killaok so squish velocity, this can be controlled by a few things, clearance is only one. what about width, angle, or shape?
Enter your email address to join: