Yes, they look quite nice for open ports!
Those transfer ports remind me of the Poulan 3750.
Yes, they look quite nice for open ports!
Those transfer ports remind me of the Poulan 3750.
That's not surprising, as the 3750/PP380 cylinder was also made by Gilardoni.
Can a cylinder with open transfers be ported in any way?
Gilardoni P&C sets are a work of art.......very nice castings.......an easy way to tell the difference without taking the whole saw apart is that the Gilardoni has an extra set of cooling fins as opposed to the Mahle XP cyl........nice saw but bad for the resale for the owner...as it stands. I have no doubt that Randy can get a lot out of this cyl....but I have had both and the mahle CP cyl and windowed piston is best for modification...IMHO......Randy can get so much more out of the XP setup...I believe......
I found an xp cylinder in my stash. I do not think that it's nice enough for this saw, though.
I have a XP top end that I pulled off a buddys' saw that the piston was scored, I think the cylinder would clean up though. Randy if you want I will drop it in the mail free and you can see if you can use it.
Joe
Wasabi?Let me know how many beans to send you.
Enter your email address to join: