timberwolf
Addicted to ArboristSite
Full circle crank and fins on the flywheel...
Full circle crank and fins on the flywheel...
Suppose too, you could put snow tires on a ferarri and then have them carefully balanced for maximum performance.
I assume they get the crank in place, and drill through the metals that are pressed together in the 3 piece crank. So lets say they put a 1/8 drill bit through there, then warmed up the crank and used the same size diameter pin into the hole for a tight fit. It really sounds like it would tighten up the crank for the high speeds this say turns.
So do you have any pics of marcel saws? Or do you have any marcel saws now?
Thanks for the pics
If it's the fins working against atmosphere that robs HP, then why not have them spin in a vacuum? Have seen this suggested before, (duct tape the starter intake grille). Anyone ever try it? opcorn:
Enter your email address to join: