Wagnerwerks
The underdog..
I could probably buy a case and coil from a 371k for 50 bucks plus shipping for you... I know my local had decent case that last week. I'm sure I could scrounge up a coil to go with it.
Swap meet...
- Thread starter Four Paws
- Start date
Help Support Arborist Forum:
MechanicMatt
Cut Split Stack Burn
Bump, and I also need the airfilter cover for a Solo 665. I think a 6400 or makita will work, so if any of you put a HD setup on and want to help me out..........
also I think one of the 576recoils will work on my 575
It was a xl123 type series of saw.
MechanicMatt
Cut Split Stack Burn
Also need a chain guide and a fan shroud for the 575. For trade I have pieces from a 55, 350 and another 575. I used a 50 and 55 to make one runner, a 345 & 350 to make one runner, now gonna take two 575's to make one, so Im going to have some spare parts.......
New, those wrap handles are right at about $100. I'm modifying a used 372 full-wrap for my 575...
tmessenger
ArboristSite Guru
Anyone got a clutch drum and matching oiler gear for a Stihl 015 in 3/8 pitch? Got a great running 015 with 1/4 pitch.
If it's the same gear used in the 020 good luck finding one in 3/8, I bought the last two new ones Stihl had a couple of years ago.
There is a seller on another site that has in stock 3/8LP clutch drum for 015 and a oiler gear in stock too. Good prices IMO.
MS460WOODCHUCK
Addicted to ArboristSite
Well guys I find myself needing a decent airfilter for a poulan 306/245. CAN'T BELIEVE I DON'T HAVE ONE...
machinisttx
Addicted to ArboristSite
If I had an extra I'd send it your way. I just picked up another 306 though and may need one myself.
dozer Dan informed me my 372xpw cylinder is a goner. Anyone have a piston and cylinder or cylinder to trade? I have a oem 503758171 272 setup to trade, the 260 carb is included but is not here yet. I have other stuff to trade also.
this is the saw I was going to upgrade. Runs well as is.
nmurph
ArboristSite.com Sponsor
- Joined
- Nov 26, 2007
- Messages
- 16,162
- Reaction score
- 7,166
I might have a spare cylinder. I could use that setup for a 61 I have setting under the bench.
Ok let me know. I will check on the carb timing.
Looking for 020T/200T parts again ! LOL Got stuff to trade or PP.
Would like to build a couple more for some strange reason ? LOL
Would like to build a couple more for some strange reason ? LOL
Last edited:
I am looking for the 51.4 mm cylinder.
Eccentric
Mister Wizard
Looks more like an XL-76 thru XL-130 series saw to me.
machinisttx
Addicted to ArboristSite
I didn't click on the pic to expand it, just glanced at the small version. If I'd looked a little closer I would have noticed that it was an XL series.
Lookin for an 044 to rebuild
Similar threads
