Had my new 35cc saw, 361P, out today.
I tell ya it cuts pretty fast if ya let it go at it's own pace. But if you try and push it'll bog down. First time cutting with it and it probably needs a few tanks through it...and the cat needs to go eventually, or a 355T muff.
But I do like using that little saw. For break-in I cut some mostly 4-5 inch ash and buried the bar in cedar a few times. Like I say, if you let it spin it'll rip pretty good.
I do need to try a 16" b&c on the CS490. And maybe try my hand at a mild port job....To hold off the urge for a 241 or 261 at least until the next dealer days.