Search results

I had this same issue and did everything you did ( new 406 carb, fuel lines filters, etc) except the new ignition coil, did the new coil solve this problem?

Have a 3 year old Echo 77o that now will not run. Starting having issues with not revving up then not starting. Pulled and slotted the mixture screws but still can't get it to run. Filter and line are clean. Thinking about a new carb? The new carb is a WYK 406 replacing the 345. I can get it for...

I just rebuilt the carb on a 460 Stihl and on the high adjustment taking it out more than 1/2 to 5/8's turn from seated is my max - it becomes too rich/dies ??? (Air filter is clean and all carb lines connected and clear). Any suggestions - Thanks.

I set up my garden with the 4 foot high perimeter fence being grounded well (with a 8 foot ground rod). On the top of each of the posts I have 3 hot wires spaced 4 inches apart. It's fun watching the critters climb to the top and grab the hot wire for a 'flight'.

$538 OTD 2 months ago here in Chi Town..........

The oil adjustment srew on this saw will only operate about 90 degrees or from minimum to max about 1/4 turn.

The oil pump is under the drum and there is a seal that connects the oil pump to the bar feed . If that seal is bad/leaking, maybe it's leaking new bar oil that 'cleaning old debri/sludge in that area and that what your seeing?

I seem to remember reading that the air filter on these earlier models had been revised from a 'plastic' to a 'metal' component design? I've checked mine for the past year after each use and see no leakage of fine dust to the carb and I don't use any silcone grease as a sealant either. But just...

Any recommendations on what compression tester to buy?

Would a gas tank vent relieve all internal pressure after the saw has been sitting for a day or two in a cool storage? I have a 460 that seems to hold a bit of pressure??? When opening the flippy cap one can hear a hiss/pressure release. Is this normal or do I need to replace the vent? Seems if...

My MS460 had labeled 1/4 turn on the "L" and 3/4 turn on the "H". I did a muff mod and the new settings were 1/2 turn on "L" and 1-1/8 turn on "H". 2700 rpm at idle.

I am rebuilding the carb on a Stihl 460. Taking apart the old one, I find there is just one gasket next to the cover on the diaphram side. The new kit came with two, a rubber one and a composite one? Wondering why two? Both are the same profile. Do I use the rubber one or the composite one? Or...

Just bought a new Stihl MS362, it starts and runs great. I was looking at the carb adjustments and found I could not adjust the low side. There is no red limiter there nor any slot for a screw driver???? (I know sounds impossible.) I did pull the high limiter off with the drywall screw method...

MS 361's are going for $519.99 w/20" here in Chi town.

Real nice looking rebuild! Just curious, all new plastic? Is there any way plastic can be reconditioned? Rubbing compound or a polish?

I agree, Walnut

Elm, maybe a Winged Elm??

361 362? The 361's (w/20") are selling for $519.99 plus tax around here. The 362 is $80 more, is it really worth it? Opinions?

362R conversion back to 362? I'm considering the purchase of a 362R for a bit better control, when cutting on some of my steep hills. However, I would still have a use for a flush cut version and would like to change out the handle for those times..Question, what are the p/n's and/or parts...

I'd agree with this wood Pin Cherry, if you live way North?