Lakeside53
Stihl Wrenching
Would I be better off applying a layer of JB Weld on the bottom side with some screen in it? I'd also put a thin layer on top and sand smooth.
Yes. Stop drill the crack...
Would I be better off applying a layer of JB Weld on the bottom side with some screen in it? I'd also put a thin layer on top and sand smooth.
Tonight I took the 08S crankcase and the 030 AV down to the automotive paint store. He scanned the 08S crankcase and came up with a very close match.
He sold me Urethane rather than Enamel. Said it was more durable. I bought a Dupont single-stage product. This stuff ain't cheap. I spent better than $120 on a pint of grey, a pint of red, activator/hardner, reducer, a gallon of lacquer thinner for cleanup, and three packs of wet/dry sandpaper.
the 08s top handle is magnesium and a pain to tig weld
The report from Pinemartin is that the shroud is lovely kirksite, AKA pot metal. It's welded but is going to require some filler to make pretty. Hopefully it'll hold up to the tiny amount of use it'll get.
You're going to use an air sprayer in your garage? lololol
I have an HVLP.. and won't use it inside (until I build my spray booth -project #4567; currenly at #2489... ).
How can I tell other than setting it on fire?
I have a high end Fuji 4 stage HVLP. They may be "Low pressure" but they are "high volume"... crap gets blown all over.
Buy a real organic respirator for the urethene..
Enter your email address to join: